INSTALL INSTRUCTIONS FOR CARCAPSULE SETUP
1. Select your place of set up by considering
the following:
A. Place the fan end nearest to
the electrical source.
B. The air intake should be away from outside doors and
heat sources.
C. The surface should be as flat as possible.
D. The basemat should be located with all sides accessible
to work the zippers.
2. Insert the fan panel into
position, smooth out the Velcro.
3. Push the male connector through
the slit in the basemat. Connect the male end to the female
end connector of the fan motor.
4. Starting at the fan end,
carefully drape the clear center section over the vehicle's hood,
roof and trunk. Zip both zippers
closed securing the tops and sides.
5. Plug the 12V transformer
into your wall outlet and your CarCapsule will start to inflate.
After
the bubble is completely inflated,
insert the filter by pushing the brim inside the flap around the
fan.
6. To increase airflow thru
the cover to dry wet vehicles or to regulate the air pressure in
extremely hot weather, simply readjust
the rear zipper closure to allow more air to flow through
the capsule. On the average the CarCapsule will change its air
volume 3 to 4 times per hour.
7. For the Silver Outdoor
Model: The outdoor model has tie-downs to prevent movement
of your bubble in the wind. The
loops for the tie-downs are located on each side of your bubble.
Also you will find a 3.5" plastic strip that you must insert
inside fan shroud. (LOOK
FOR BELT LOOPS) This will give
the pouch form to insert the filter. Next you will find a 1" vinyl
strip with velcro on both ends that attaches under filter to
keep in place.
A. Attach a string
to an eyelet on the top of the bubble. Tie a secure knot.
B. For extra securing, slide a pole into the loops at the
top of the Outdoor Capsule before Step A.
C. If you wish to attach bubble to ground. Drive a
stake into the ground at a forty-five degree angle
away from your bubble. Attach the string to the stake. Repeat
A and C on other side of your bubble.
Stakes are not included and can be purchased from your local hardware store.
CARE INSTRUCTIONS FOR CARCAPSULE
1. The clear unit is for indoor
use only. The silver unit is for outdoor use.
2. Do not put any material under
the floor section, it will only trap moisture! This
can create mold or mildew.
3. Locate the air intake filter
away from outside doors or sources of heat such as water heaters,
furnaces, roll-up metal doors or washer/dryers.
4. Keep the air filter clean
by hand washing in warm water. You may use a mild dish soap
if necessary.
5. Do not place any source of
heat inside the cover (not even a light bulb).
6. If CarCapsule is first used
in extremely cold climates, blow up in a warm area to help PVC
become pliable.
7. When you set up your CarCapsule
for the first time, it will have a lot of wrinkles. As it
is kept inflated, the remainder of
the wrinkles will work themselves out.
8. If your CarCapsule gets dusty
you can use a car duster. To remove stains, use warm water
and a mild dish soap. |
